AX53

Sorry if it’s been posted before. I just found it

A little sunday test run with the Chaser throttle conversion. :) Before I had to redline 1st to drift it, now it goes in mid range 2nd. Enjoy :D

This is my Chaser GX100 throttle body for a Beams 1G-FE VVTi. Exact same engine as IS200 but different throttle without ETCSi (drive by wire) and sadly a different TPS sensor design. Hence the adapter. Here is a test fit of my custom 3D printed IACV block off plate and TPS adapter so I can fit the IS200 TPS onto this throttle body. And then fit this throttlebody on my IS200 engine lol

Drifting the 80’s Pessima in BeamNG!

There is a lot of confusion about this in the car community apparently. I don’t see how it’s so hard to understand. This is NOT an Anti-lag system. Just because a car cuts ignition and shoots flames doesn’t mean it’s got anti lag. Like-wise just because a car can build boost in neutral doesn’t mean it’s got anti lag. This is called 2-step or Launch control Write this down. THIS is real Anti-lag. A system which completely remove turbo lag all together. Commonly used on rally cars. Write this down.

This is the Group-A EG6 SiR mod which I’ve in turn modified with: Torque curve replicated from a k20a Gear ratios taken from k20a Official tyre model from AE86 tuned Sound bank from an Integra Type-R mod. I hope you like it :)