See The Ford GT's Amazing Aero Package At Work During Wind Tunnel Testing

The new Ford GT's dramatic looks are all down to a range of extreme and very much functional aero devices. With that in mind, it's fascinating to see how the air flows over the GT during wind tunnel testing

There are multiple bits of aero design you can see at work here. Firstly, there’s the active rear wing, which when retracted can give extra downforce, as well as having the ability to tilt and act as an air brake. There’s the moveable flap at the front that dictates how much air is sent to the rear diffuser, and we also get a good look at the flying buttresses which aid airflow to the clever wing. And you thought the new Honda NSX was geeky…

Sponsored Posts

Comments

Boosted69420

is it just me or the back end looks like a awkward face?

07/14/2016 - 09:40 |
1 | 1

it has been said many times before, it looks like a pig from angry birds.

07/14/2016 - 10:18 |
8 | 0
Roget

The face of the car would look a Killer Whale if colored white in bottom, outlined white headlight and rest black

07/14/2016 - 09:48 |
1 | 1
Anonymous

I find this strangely calming to watch

07/14/2016 - 10:03 |
7 | 1
Anonymous

In reply to by Anonymous (not verified)

I found this titillating to watch.

07/14/2016 - 12:28 |
1 | 0
FLixy Madfox

Science, it brings cars like this to life

07/14/2016 - 10:13 |
57 | 2
RoyP

Windtunnel •-•

07/14/2016 - 10:14 |
12 | 0
Manuel w/Clutch

GREYt aerodynamics

07/14/2016 - 10:23 |
1 | 0
k_badam

I clicked on this article expecting to see massive cats driving the new ford GT. I very sad now :(

07/14/2016 - 10:33 |
20 | 1
TheNOISYCar

This car is so beautiful and it’s sad that all the pre-production ones will be destryoed :(

07/14/2016 - 10:50 |
1 | 0

What?

07/14/2016 - 13:35 |
1 | 0

You mean the road prototypes? I knew a guy with a road prototype 918 too bad merica wants all of them crushed

07/23/2016 - 12:02 |
0 | 0
On the Apex

THIS. This is what motivates me to be a mechanical engineer and to work on aerodynamics!

07/14/2016 - 14:52 |
2 | 0
On the Apex

Also, this test seems much more focused on pure demonstration rather than actual aerodynamic testing. You can notice this because there is no moving ground to prevent the formation of a boundary layer that shouldn’t be there (a boundary layer is a thin layer of air in which viscosity has an effect on its speed and behavior. As a car is moving relative to the ground, there shouldn’t be any boundary layer above the ground, only just below the car’s untertray). Without a moving ground or some device to prevent this boundary layer from forming, any downforce/drag measured would be incorrect. Hence, this test would be good for 1-demonstration, 2-noise testing (as the guy in the video says) or 3-evaluation of cooling and vibrations.
Still, what a lovely sight this GT’s aero.

07/14/2016 - 15:04 |
0 | 0