Roll bar dimensions

Had a fellow CTzen ask for roll bar dimensions in order to help make his own. May help others as well. These are rough dimensions so keep that in mind. Roll bar used was a Blackbird Fabworx GT3, diameter tubing is either 1.5 or 1.75 inches, not sure. I apologize in advance for idiotic imperial measurements lol.

MEASUREMENTS

Pic #1 length of top of roll bar - approx. 36 inches
Pic #2 length of bottom of roll bar - approx. 48 inches
Pic #3 length of harness bar - approx. 44 inches
Pic #4 height of roll bar (from the REAR, backing plate to the top) - approx. 28 inches
Pic #5 height of roll bar (from the FRONT, backing plate to top) - approx. 32 inches
Pic #6 height of harness bar (from FRONT, backing plate to harness bar) - approx. 20 inches
Pic #7 length of X brace tube - approx. 36 inches
Pic #8 length of HALF of X brace tube with GT3 gusset - approx. 17 inches
Pic #9 length of GT3 gussets - approx. 5.5 inches