Help! FA20 engine size needed!
Ladies and Gentlemen get your tape measures out.
I’m trying to build a project car needing an FA20 engine, problem: no dimensions of the engine block.
It will be a make or break for the project as i would prefer to use this engine.
Dimensions needed are as follows:
Height: sump to top of intake manifold
width: cam cover to cam cover
Depth/length: Timing belt to gearbox casing
Preferably in mm.
Comments
I can’t find anything about the size of the engine, have u considered emailing either Toyota or Subaru or going to a dealer and asking if you can measure it or they have data on it
well this is going to be fun! all the dealers are currently shut in the UK. and won’t open till 8 tomorrow.
Haha I’m from the UK to, what’s the car u are putting a FA20 in??
hopefully a suzuki cappuccino, in Greatest Britannia
Well a Toyota gt86 is 4240mm long, 1775mm wide and 1320mm high (not engine measurements) if you compare it to that Suzuki you might be able to get a rough idea of if that car is big enough for it. Idk just a idea I might be wrong
eh, scaling is not a bad idea, but considering the gnats nudge of clearance i’m probably going to have. i’d rather not take chances
Just went out with a tape measure.
Looks like,
32 inches wide
18 inches deep
And I couldn’t get a good height measurement, but my guess is somewhere around 22 inches for height.
813mm wide
457mm deep
559mm high